TOP FOLDING STOCK
WITH PISTOL GRIP
INSTRUCTIONS

Part#TFS0600

Patent Pending

MAKE SURE YOUR SHOTGUN IS UNLOADED
BEFORE STARTING!

1) Remove the existing recoil pad from your shotgun stock by unscrewing the 2 Phillips head screws in the rear of the pad.

2) Use a long flat blade screwdriver to remove the stock bolt from the inside of the opening in the rear of the stock.

3) Select the adapter for your shotgun. The Mossberg and Maverick require no adapters. The Remington/Norinco and Winchester adapters are marked and shown left.

4) Select the mounting bolt supplied for your shotgun. Norinco 98 Series for law enforcement only! A metric 6 x 50mm bolt must be purchased for the Norinco.

6) The stock comes with a sling swivel stud mounted on the left side for right handed shooters. If you are left handed, unscrew the sling swivel stud and remove the cap and the pivot pin, then mount it on the opposite side.

Winchester Adapter #SPG1035
(Smaller adapter on left)

Remington & Norinco 98 Adapter #SPG0130
(Bigger adapter on right)

Mossberg/Maverick Bolt 5/16” - 18 x 1 1/2”

Remington Bolt 1/4” - 28 x 2”

Winchester Bolt 5/16” - 24 x 2 1/2”

Norinco 98 Series 6 x 50mm Metric Bolt (must be purchased)

       
Washer

CAUTION:
Do NOT overtighten any screws.

TO CLOSE: Press the the quick-release button (located on the left side of the grip), while lifting the stock upward. As the arm closes down on the barrel, the butt plate will fold flat. The quick-release button will snap out securely locking the stock in the closed position.
TO OPEN: Press the quick-release button while lifting the stock away from the barrel. When the stock is fully open, the button will lock into position.

The firearm will function in the open or closed position.