Featured Treasures

One Component of Advanced Technology's 12GA Shotgun System

Rear Buttstock with Pistol Grip
Instructions
Part#SPG0100

Patent Pending

***MAKE SURE YOUR SHOTGUN IS UNLOADED BEFORE STARTING***

1) Remove the existing recoil pad from your shotgun stock by unscrewing the 2 Phillips head screws in the rear of the pad.

2) Use a long flat blade screwdriver to remove the stock bolt from the inside of the opening in the rear of the stock.

3) Select the adapter for your shotgun. The Mossberg and Maverick require no adapters. The Remington and Winchester adapters are shown left.

#SPG-0135 Winchester Adapter
(smaller adaper on left)

#SPG-0130 Remington & Norinco Adapter (bigger adapter on right)

Mossberg
Spacer
#SPG-0112

Remington Spacer Short #SPG-0114
Must use with short OR long screw.
(Cut to fit Norinco 98 series -see diagram left)

4) Select the rear spacer. Remington has 2 rear spacers for a long or short stock bolt. The longer bolt requires both spacers. The Winchester does not require a rear spacer. The Norinco 98 uses the original metric stock bolt, the platform #SPG-0111, and the Remington Spacer #SPG-0114 must be cut to length.
(See diagram left to cut Remington Short Spacer to fit Norinco 98 Series Shotgun)
NOTE: ALL SHOTGUNS USE THE PLATFORM.

To fit Norinco 98 Series, cut the Remington Short Spacer as shown, then follow Remington instructions.

5) Place the stock bolt through the spacer(s) and platform and install in the rear of the Pistol Grip Stock. With the stock bolt extending out of the front of the stock, place the front adapter over the bolt and against the stock. Place the Pistol Grip Stock up to the rear of the receiver and secure by tightening the original stock bolt.

6) Place the new recoil pad on the rear of the stock and secure with the 2 screws provided.