SHOTSHELL
HOLDER
INSTRUCTIONS

Part#SHO-0500

Patent Pending

MAKE SURE YOUR SHOTGUN IS UNLOADED
BEFORE STARTING!

1) Cut out mounting template on the back of packaging.

2) Place 5 shotgun shells in holder and position on stock.

3) Locate proper position on stock so there is no interference with cheek, shoulder, etc. Note: The Shotshell Holder may be mounted on either side of the stock for both left and right-handed shooters.

4) Place mounting template where you wish to mount the Holder and tape it down.

5) Mark ONLY the corner holes through the template with a sharp object. ie., nail, awl, punch.

6) Drill the 4 holes using a 7/64" drill bit.

7) Mount the Shell Holder using the 4 flathead screws supplied. Then insert all 5 shotshells and check for "snug" fit.

NOTE: For a tighter fit, install the 2 middle screws.