Standard Shotgun
Forend Instructions
for Winchester

Part#SFS0400

Patent Pending

MAKE SURE YOUR SHOTGUN IS UNLOADED
BEFORE STARTING!

1) Cycle action once to make sure hammer is cocked and engage safety.

2) Depress slide release and pull forend approximately halfway rearward, loosen magazine cap and remove barrel.

3) Remove trigger group retaining pin by tapping it out with a blunt pin no greater than 1/4 inch in diameter.

4) Place shotgun upside down and pull out trigger group by lifting up at the rear.

5) Turn the shotgun back upright and pull forend forward and off magazine tube. Remove bolt from action bars.

6) With forend removed, unscrew forend ring nut (with Tee wrench supplied) from the front of tube and remove old forend by pulling it forward off the tube.

7) Locate front and rear adapter for your shotgun. (USE SCISSORS TO REMOVE PLASTIC BRIDGE). Note: The part numbers are located on the inside of the tube for each of the front and rear adapters.

FRONT Adapter Marked
MF1 = Mossberg 500/590 Long
MF2 = Mossberg 500/590 Short
RF = Remington 870 & Norinco 98
WF = Winchester 1200/1300

REAR Adapter Marked
MR = Mossberg 500/590
RR = Remington 870 & Norinco 98
WR = Winchester 1200/1300

8) (USE SCISSORS TO REMOVE PLASTIC BRIDGES FROM FOREND) Place the adapters on both the front and rear of your new forend and slide in place over the forend tube.

9) Place ring nut on forend tube and tighten.

10) Place forend back on magazine tube and replace bolt in the action bar slots as previously removed.

11) Align action bars with openings in the receiver and pull the forend rearward.

12) Turn the shotgun upside down and replace trigger group and retaining pin (see step 3 picture, reverse).