Standard Shotgun
Forend Instructions

Part#SFS0400

Patent Pending
FOR Remington 870 or Norinco 98 Series.

MAKE SURE YOUR SHOTGUN IS UNLOADED
BEFORE STARTING!

1) Engage safety switch.

2) Pull forend all the way rearward and then forward approximately half way.

3) Unscrew magazine cap and remove barrel.

4) Depress and hold the left shell stop.

5) Slide forend forward off magazine tube. Note: The bolt and slide block will also be removed.

6) With forend removed, unscrew forend ring nut (with supplied Tee wrench) from the front of tube and remove old forend by pulling it forward off the tube.

7) Locate front and rear adapter for your shotgun. (USE SCISSORS TO REMOVE PLASTIC BRIDGE) Note: The part numbers are located on the inside of the tube for each of the front and rear adapters. Part#RR (Rear) and Part#RF (Front).

FRONT Adapter Marked
MF1 = Mossberg 500/590 Long
MF2 = Mossberg 500/590 Short
RF = Remington 870 & Norinco 98
WF = Winchester 1200/1300

REAR Adapter Marked
MR = Mossberg 500/590
RR = Remington 870 & Norinco 98
WR = Winchester 1200/1300

8) (USE SCISSORS TO REMOVE PLASTIC BRIDGES FROM FOREND) Place the adapters on both the front and rear of your new forend and slide in place over the forend tube.

9) Place ring nut on forend tube and tighten.

10) To reassemble, slide forend back on magazine tube and replace bolt and slide block. Place action bars into receiver and pull rearward until it stops. See above.

11) Press right shell stop. The forend with the bolt will slide further rearward and stop again. Now press left shell stop and the forend will travel fully to the rear.

12) Slide the forend forward approximately halfway and replace barrel and magazine cap.