Featured Treasures

Assembly Instructions for .303 or .308 Enfield No 1, Mk 3

.303 or .308 Enfield Monte Carlo Stock
Part#ENF0013

***MAKE SURE YOUR RIFLE IS UNLOADED BEFORE STARTING***

To identify the No1, Mk3, it has the rear sight located on the barrel.

STEP #1 Remove Magazine. Open bolt and examine chamber to make certain the chamber is empty.

Fig 1

STEP #2 Remove the screw-clamped barrel band and upper handguard. (Figure 1) Remove the lower forearm-to-barrel attaching screw. (Figure 2) Remove the two screws in the trigger guard. Remove trigger guard, noting the relationship between the trigger and the sear as reference for reinstallation later. Lay rifle (magazine well facing upward) on bench and carefully work stock forearm upward and off barreled action. Lift off upper rear handguard.

STEP #3 Remove buttstock by opening trap door on buttplate and loosening attaching bolt. (Figure 3) (Bolt is usually a slotted-head so a large blade screwdriver will be needed to remove it.) Note: Some of these bolts may be extremely tight.

Fig 3

STEP #4 Remove buttplate from Monte Carlo stock. Install the new buttstock using the original rear stock attaching bolt. Tighten bolt. Reinstall buttplate.