|
STEP #1 Start 10-32 x 1/4" Allen
Screw into the top of the mounting column with supplied Allen Wrench.
STEP #2 Place the mounting column over
the front sling swivel stud. Align the thru holes; then install and
center the retaining pin. Tighten the Allen Screw. Install new 1/2”
threaded sling swivel stud and tighten.
STEP #3 Remove backing from Neoprene
Pad. Align and affix to bipod mounting bracket.
STEP #4 Align and install Bipod over the
mounting column with legs parallel to the barrel and pointing toward
muzzle. (Depress “Snap-N-Lock” button and rotate legs 180°)
STEP #5 Place nylon washer over mounting
column. Install mounting nut onto column and hand tighten plus
1/4 turn maximum. Failure to follow this procedure could result in
damage to stock. Do Not Overtighten!
STEP #6 Your Advanced Technology, Inc.
Bipod is now in place and ready to use.
STEP #7 To adjust legs forward, down, or
rearward simply depress the “Snap-n-Lock” button and rotate leg to
the desired location. Then release the button.
STEP #8 To adjust height (inner leg)
twist knurled thumbscrew 1/4 turn and legs will freely drop. Retighten
thumbscrew. To retract legs simply invert rifle and repeat process.
|
Welcome to RB's Treasures. 
