REAR PISTOL
GRIP INSTRUCTIONS

Part#SRG-0200

Patent Pending

MAKE SURE YOUR SHOTGUN IS UNLOADED
BEFORE STARTING!

1) Remove the existing recoil pad from your shotgun stock by unscrewing the 2 Phillips head screws in the rear of the pad.

2) Using a long flat blade screwdriver remove the stock bolt from the inside of the opening in the rear of the stock.

3) Select the adapter for your shotgun. The Mossberg and Maverick require no adapters. The Remington and Winchester adapters are shown left.

Winchester Adapter (smaller)
Remington Adapter (bigger)

Washer Included

Mossberg or Maverick Bolt
5/16 -18 x 1.5"

Winchester Bolt
5/16-24 x 2.5"

Remington Bolt
1/4 -28 x 2"

4) Select the mounting bolt supplied for your shotgun.
See Left. (Norinco 98 Series for Law Enforcement Only. A metric 6x50mm bolt must be purchased)

5) Place the bolt, with supplied washer, through the back of the grip and adapter (if used) and secure to the shotgun receiver by tightening bolt.

6) Place pistol grip end cover at the rear of grip and press in place.